When looking to purchase a powerful Ozone Generator that will produce above the 0.2 PPM “safe” level, there is one pre-requisite that should be considered for maximum safety and efficiency, that is for the Generator to have a built in Ozone Destruct cycle. Simply put there are 3 main reasons to buy an Ozone Generator with built in destruct capability.
1 – Speed
If an Ozone machine does not have a destruct cycle incorporated within each cycle you will have to leave the room or area unoccupied for a long period of time after the cycle has finished. This is to enable the Ozone to naturally decay. The actual length of time can vary considerably depending on which Generator is being used but on average, at a PPM of 2.5 (a fairly common amount in removing odours) in an area of approximately 60 M3, the room should be left for roughly 4-6 hours before anyone enters. In comparison to this, Ozone Cleans OC1500 can fully deodorize this space in between 5-15 minutes and our OC700 within 15-30 minutes, with the built in destruct capability leaving the area safe to occupy immediately afterwards.
2- Safety
Just because you have left the room for an extended period of time it does not mean that the area is safe to enter as you would have no idea if the level of Ozone has depleted enough, since there are a few variables in the depletion of Ozone such as temperature, humidity and what furnishings are inside. The only procedure that would negate any risks would be to enter the room with a specialist mask and an Ozone Monitor to check the levels of Ozone are below 0.2PPM. This adds a high extra cost of the Ozone Monitor and increases labour costs.
If you do consider purchasing an Ozone Generator without the destruct cycle you should make sure the supplier provides you with extensive laboratory testing against room sizes and cycle time for how long to leave the areas after the cycle.
3 – aesthetics (or better results)
This last reason for using Ozone equipment that will also destroy any residual Ozone is a fairly logical one. The resulting smell of Ozone will be much more powerful than a unit where the Ozone is removed during the cycle. This has been a very common complaint especially in hospitality that the Ozone smell is “too strong” and invariably it would be due to the fact that a cheap Ozone machine that does not destroy the Ozone is being used. Another factor resulting in the strong after effects of Ozone is that there is no “dwell period” in the cycle. Many Ozone machines on the market that destroy Ozone during the cycle are 2 part processes of Production and then Destruction immediately after with no dwell period in between. The result of this would be twofold, inefficiency in operation as the Ozone does not have time to disperse and penetrate fabrics and furnishings plus a stronger residual Ozone smell due to the higher concentration around the machine. Other factors could be operatives are not trained in the use of the machine and they are using cycle times that are too long for the area to be treated.
Ozone Cleans’ OC1500 and OC700 are manufactured to the highest specification of Research and Development where there is a 3 part process in every cycle of Production, dwell and Destruction designed for the most efficient and safe results. We also firmly believe in Training with certification provided.
Not sure where to begin when it comes to an Ozone Generator? Speak to our sales team today! Call us on 020 8883 2756 or visit here.

